Monday, May 02, 2016

Piezo Power Shoes with LEDs

Walking is a Source of Energy that can be Harvested to Power LEDs or Wearables. It may one day Recharge your Smartphone or tablet. Just start running when the Battery goes low on your Phone. -

A question in the G+ Community lead to a study of resources in the web for this college project.

Here is the first page that will interest you - Parasitic Power Shoes Project

Energy Harvesting in Shoes for Small Devices

"environmental energy sources can begin to replace batteries in certain wearable subsystems. In this spirit, this effort has examined devices that can be built into a shoe, (where excess energy is readily harvested) and used for generating electrical power "parasitically" while walking."

Goal: To develop a rugged piezoelectric shoe insert and complementary conditioning electronics for unobtrusive, parasitic harvesting of the compression energy normally lost while walking

See also Energy Scavenging with Shoe-mounted Piezoelectrics

"Abstract of pdf below — Much energy harvesting research has been conducted with ceramic based piezoelectric transducers on account of their relatively large electrical response to mechanical excitation. However, notwithstanding their comparatively low piezoelectric coefficients, piezoelectric polymers too hold promise as energy harvesting materials due to their flexibility and strength which make them ideal candidates for use in more diverse applications. "

Piezoelectric Energy Scavenging In Shoes

"The energy harvester devices are capable of capturing environmental energy and supplanting the battery in a stand-alone module, or working along with the battery to extend substantially its life. Vibration is considered one of the most high power and efficient among other ambient energy sources, such as a solar energy and temperature difference."

Development Of Energy Harvesting Source From Piezoelectric Shoe

Piezoelectric materials (PZT) can be used as mechanisms to transfer ambient vibrations into electrical energy that can be stored and used to power other devices. With the recent surge of micro scale devices, PZT power generation can provide a conventional alternative to traditional power sources used to operate certain types of sensors/actuators, telemetry, and MEMS devices.

Power Walking - STAB Resources

"i started by looking at the self-powered shoe from Responsive Environments group and wanted to acquire a large piece of piezo film that could be embedded in the sole of a shoe. After consulting with Mark Feldmeier, I learned that the piezo elements large enough to generate enough power for the shoe would be too expensive to use if I wanted to make more than just a single prototype."

Piezo-Powered Self-Lighting Circuit